Help

Analysis of the cause of slippage of stainless steel mesh belt

Analysis of the cause of slippage of stainless steel mesh belt:
1. The initial supporting force is very small. Insufficient support of the stainless steel mesh belt leaving the drum causes the stainless steel mesh belt to slip. This situation usually occurs at the moment the conveyor starts, and the way to deal with it is to adjust the tensioning equipment to increase the initial support force.Analysis of the cause of slippage of stainless steel mesh belt:


1. Too fast-starting rate causes slipping. At this time, the starting rate of the conveyor should be adjusted to slow down the starting rate, and it is reasonable to start after 2 jogs.


2. The load of the mesh belt is too large. At this time, slipping also has certain benefits, and it has practical effects on the maintenance of electricity. If the conveyor is overloaded and transported for a long time, it is likely to be burnt down. Therefore, when using the conveyor, you must have an approximate grasp of the net weight of the load. 


3. The initial supporting force is very small. Insufficient support of the stainless steel mesh belt leaving the drum causes the stainless steel mesh belt to slip. This situation usually occurs at the moment the conveyor starts, and the way to deal with it is to adjust the tensioning equipment to increase the initial support force.


4. The end roller bearing is damaged and does not rotate or the left and right roller bearings are damaged and does not rotate, causing slippage. The reason for the damage of the tail end roller bearing is that the tail end of the machine is too up and down, and there is no immediate repair or replacement of the damaged or inefficient components, which increases the friction resistance and causes the belt to slip.


5. Insufficient sliding friction between the transmission drum and the stainless steel mesh belt leads to slipping. The reason is mostly water on the stainless steel mesh belt or wet and cold natural environment. The solution is to add some resin powder to the drum.


6. The load of the stainless steel mesh belt is too large, and it will slip if it exceeds the working capacity of the motor. The beneficial side of skidding at this time is that it has a protective effect on the motor. Otherwise, the motor will be damaged if it is clicked for a long time and overload operation. However, skidding is a safety accident for operation. To deal with the slippage of the stainless steel mesh belt, it is necessary to look for the slippage first, and then take measures to deal with the slippage.


Analysis of the cause of slippage of stainless steel mesh belt